Modular Walk-in Concept 

Corner panels are 12" x 12" on the exterior sides, and interior corner is fully coved.

Tee walls are used in the construction of multi compartment walk-ins, by providing a complete break in the metal, they prevent thermal conduction from one compartment to another compartment.

Posi-loc locking assemblies provide perfect alignment of walls, ceilings, floors, corner panels and door frames, the assemblies are permanently foamed-in-place in the tongue are groove edge of all panel.

Floor and ceiling panels utilize the modular construction concept of foamed-in-place insulation, tongue and groove panel edges with posi-loc assemblies and double gaskets.

Floor panels are fabricated with a heavier gauge interior surface to with-stand heavy traffic and double gaskets.

Reach in system 

* Less installation cost

* Shortening building process

* Best hygiene

* Best quality

Only a few large electric refrigerators and freezers can be replaced instead of one big chamber system at same provision area, excluding any heat or refrigerant system for chamber. 

 High Performance & High Quality 

The door construction is made with magnetic rubber and specially sealed packing to prevent refrigerant leackage to maintain freshness, including door locking device with key.

The unit uses highly efficient condenser and body panels are made of CFC-free polyurethane foam to keep the highest insulation.

The automatic defrosting function is provided by strong air circulation and easy-way digital temperature controller is at control panel installed.

Pin-type evaporator with ventlator helps efficient air circulation to keep the best cleanliness of equipment.

Condensing water is gravitationally drained through drain line at rear side.